![]() The Axsguard will automatically create the required firewall rules to allow traffic to pass through the tunnel. Make sure to set the settings exactly the same as on the Fortigate. ![]() If you can’t find the settings that correspond to the settings on the Fortigate, you can add them in the IPSec -IKE, and IPSec - ESP menus. Let’s go ahead and create a new tunnel on the Axsguard. Axsguard, on the other hand, uses minutes for the lifetime. One thing to pay attention to is the key lifetime, Fortinet uses seconds to express the lifetime on its devices. If you cant find the VPN router setup tutorial for your routers firmware on the following list, continue scrolling down for further instructions. The same principles apply to the configuration of the Axsguard. You will still need to configure a route and firewall rules for VPN traffic. You can choose between a subnet, IP range or a single IP address. In the phase 2 settings, you can specify what addresses should be configured on the tunnel. ![]() Keep this in mind when you’re behind a NAT device. Fortigate will automatically send its public IP as the local ID. In this example, I’m using 3DES and SHA1. While 3DES is still considered as secure, I would recommend against using it in production, mainly because of the speed. If you want to use the public IP address as the local ID, leave the field empty. Create a new tunnel and select the Custom VPN Tunnel template. ![]() Let’s start by creating the tunnel on the Fortigate. Today I was building a tunnel between a Fortigate 70D and an Axsguard Gatekeeper, as you can guess, things didn’t go as planned. If you’ve ever had the “pleasure” of building an IPSec tunnel between 2 endpoints from different vendors, you’ll know how smooth that usually goes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |